Installation Guide

Stinger HEIGH10

Radio Replacement Kit

for 2011-2018 Jeep Wrangler JK

SR-JK11H

AAMP Global is not a󰀩liated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms

OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identication purposes only. It is not

implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.

Pacific Accessory Corporation

Page 5

Rev: V2

Date:052521

Section 2: In-Vehicle Harness Connections and Preparation (cont.)

Part One: Dual USB Extension (SSUSB2) (cont.)

Step 4 Step 5

Reconnect and reinstall the

climate control panel. Route the

two USB cables up to the radio

opening, making sure to route

them behind the metal bracket.

Install the optional USB cover and

feed the USB cables through the

front of the panel. Secure with the

anged nut and then lock with the

lock nut.

Step 1

Part Two: GPS Antenna

Step 1 Step 2 Step 3

Clean the indicated area above

the right side of the instrument

cluster.

From the HEIGH10 box, stick the

metal plate to the surface and

place the magnetic GPS antenna

on the plate.

Route the blue GPS connector

behind the metal bracket and into

the radio opening. Bundle and

secure the excess antenna cable

behind the instrument cluster.

The GPS antenna is required for proper operation of Apple CarPlay and Android Auto, in addition to the optional GPS if

installed. The GPS antenna and mounting plate are included in the HEIGH10 hardware.