Installation Guide

Stinger ELEV8 or HEIGH10® Radio Replacement Kit

for Jeep Wrangler JL and Jeep Gladiator JT Vehicles

SRK-JW18EH

AAMP Global is not a󰀩liated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms

OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identication purposes only. It is not

implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.

Pacific Accessory Corporation

Page 11

Rev: v3

Date:100620

Section 4: In-Vehicle Harness Connections and Preparation (cont.)

Part Three: Chime Speaker

Step 2

Route the chime speaker cable

behind the dash panels to the

radio opening.

Remove the knobs from the

chime speaker and mount the

chime speaker bracket to the

metal brace underneath the

steering column using the double

sided tape, mounting bolts, and

wing nuts. Then, reinstall the

speaker to the mounting bracket.

(Two holes must be drilled into

the metal brace to secure the

speaker mounting bracket to it.)

Step 1

Part Four: USB Retention Adapters

Step 2

Connect the USB-UN2 adapter to

the factory USB port in the back

of the center console, then route

the cable along the passenger

side of the center console to the

radio opening.

Connect the USB-UN1 adapter

to the factory USB connector that

was unplugged from the factory

radio.

Step 1

Note: Installation of

the chime speaker

is only required in

vehicles with safety

group features.