Installation Guide
Stinger ELEV8 or HEIGH10® Radio Replacement Kit
for Jeep Wrangler JL and Jeep Gladiator JT Vehicles
SRK-JW18EH
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not aliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identication purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 4
Rev: v3
Date:100620
Step 2
Step 1
Push up on the glove box stop
tab to allow the glove box to
fall forward out of the glove box
opening, then unhinge the bottom
of the glove box and remove.
Open the glove box and unclip
the soft-open sliding arm clasp
from the left side of the glove box.
Step 3
Step 2
Step 1
Disconnect the inner center
console USB port connector.
While pulling the panel towards
the rear of the vehicle, use a
plastic panel removal tool to
release the clips securing the
panel in place and remove.
Open the center console storage
lid, then remove the two T20 torx
screws securing the rear console
panel in place.
Part Two: Glove Box Removal
Part Three: Center Console Panel Removal
Section 1: Disassembly (cont.)