Owner's Manual

42
43
StingerElectronics.com StingerElectronics.com
®
®
SOUND SETTINGS SOUND SETTINGS
Sound Settings > Crossover
Selecting Crossover from the Audio
Menu Bar will access the internal
electronic variable crossover. Crossover
settings can be saved and recalled via
Presets.
Front/Rear/Subwoofer Channels
Select Front, Rear or Subwoofer to set
crossover.
Slope [6dB-12dB-18dB]
Adjusts the slope of the crossover.
Frequency
[BYPASS-25-40-63-80-100-160-250Hz]
Adjusts crossover frequency. Front and Rear
channels are High Pass and Subwoofer is
Low Pass.
Level [-12–0]
Adjusts signal level. Channel levels can be
adjusted regardless of crossover settings.
Sound Settings > Time Correction
Selecting Time Correction from the Audio
Menu Bar will access the Time Correction
settings. Time Correction settings can be
saved and recalled via Presets.
Time Correction compensates for the
uneven distances between the speak-
ers and a listeners ears. Time Correction
delays signals from the closest speaker(s),
so that all the sound arrives at the listen-
ing position at the same time, giving the
listener a more accurate, life-like stereo
image.
To set Time Correction, select a listening
position, for example the driver's seat
headrest. Then, measure from each
speaker to the listening position. Set Units
to Inch, and input the speaker distance
values into the appropriate positions using
the +/- buttons.
Saving Crossover Settings
There are 6 user Presets that can be
used to save Crossover settings.
When you are done adjusting the
Crossover, touch and hold a Preset
location to save the settings. The Preset
will highlight.
Saving Time Correction Settings
There are 6 user Presets that can be used
to save settings. When you are done
adjusting the Time Correction, touch and
hold a Preset location to save the settings.
The Preset will highlight.
Graphical representation of crossover
Slope, Frequency and Level.
Select milliseconds or inches
Front Channel = Blue
Rear Channel = Orange
Subwoofer = Green
Active (Selected) = Yellow
NOTE: If the vehicle is equipped with a factory amplier,
Crossover is not selectable by default.
NOTE: If the vehicle is equipped with a factory amplier,
Time Correction is not selectable by default.