Installation Guide

ManualsBrandsSTKR ManualsCommercial LightingIntegrated LED Multi-Point Illumination Motion Sensor Lighting System

INSTRUCTIONS

QUESTIONS? Before returning to your retailer, call our customer service department at

704-508-1031, Monday - Friday 8 a.m. - 5 p.m. ET, or email us at info@StrikerConcepts.com

IMPORTANT

We have provided many important safety messages in this manual and on your appliance. Always

read and obey all safety messages.

TOOLS

Required: Drill, Screw Driver, Pen/Pencil, Ladder

PARTS (included)

1x Main Hub Light

4x Pod Lights

4x Ceiling Plates 8x Screws 8x Anchors

INTRODUCTION

Unlike a traditional light xture which has a single point of illumination, the MPI creates ve points of

light, all from your existing light xture!

These 5 points spread light to all corners of the room, lling the entire space and reducing shadows

caused by single point illumination.

This system installs in minutes and is powered by a standard light socket, eliminating the need to hire

an electrician to properly light large spaces like a garage, attic, or basement.

This is a safety alert symbol.

This symbol alerts you to potential hazards that can hurt you and others.

“Entire Room LiGhtinG”

Summary of content (4 pages)

PAGE 1
“Entire Room LiGhtinG” INTRODUCTION Unlike a traditional light fixture which has a single point of illumination, the MPI creates five points of light, all from your existing light fixture! These 5 points spread light to all corners of the room, filling the entire space and reducing shadows caused by single point illumination. This system installs in minutes and is powered by a standard light socket, eliminating the need to hire an electrician to properly light large spaces like a garage, attic, or basement.
PAGE 2
INSTALLATION 1 • Ensure light switch is OFF • Screw MPI Light into lamp holder 2 • Plug in all Pod lights. Feel for ROUND ports and stick plugs into ports x4 Do not plug lights into USB port 3 • Let all four Pods hang 4 • Position the first light in the desired area. • Position ladder in that location • Go up ladder with Pod. Be careful • Find exact desired location on ceiling RECOMMENDED: Position Pod minimum 3 feet from surrounding wall. Max length from hub is 9.
PAGE 3
INSTALLATION 6 • Position plate and drive screws into drywall anchors or joists • Lightly seat screws with a screw driver or drill. Do not overtighten 7 ATTACH POD: • Position Pod light over ceiling plate and rotate clockwise, until locked in place. TO REMOVE POD: • Press firmly up on the Pod • Rotate counter-clockwise Ensure tabs are facing down 8 • Tighten cable by rotating Pod counter-clockwise ADJUSTING MOTION SENSOR Set motion sensor to desired sensitivity or leave off if using like a light bulb.
PAGE 4
SPECIFICATIONS Model # 00194 Electrical Specifications: 100-240V, 50/60 Hz, 0.52A, 60 W Base: Medium Screw (E26) Environment: Indoor use only, dry location Not Dimmable Light Output: 7500 Lumens Total, 5400K color temperature Motion Sensor: Adjustable 360˚ motion detection Motion Sensor Modes: Off, Min-Max sensitivity Motion Sensor Timer: 2 min USB Port Output: 5V 1.2A Hub Dimensions: 7.6” x 7.5” x 4.25” (193mm x 191mm x 108mm) Weight: 1.1 lb (500g) Pod Dimensions: 4.1” x 3.