User's Manual

1. Power ON
a. Press the power switch on the Base and the red LED should turn ON
b. Press the POWER button on the remote. The green LED on the Base should lit and video should
be displayed.
3. Power Off
a. Press the POWER button on the Remote while power is on will turn off the power of the Remote
and put the Base in standby mode.
b. The green LED on th eBase should be off and the red LED should remain ON.
c. To switch off power to the Base, press the power switch. The red LED will be Off
4. CH+/CH-: to adjust the TV channel
a. Press the CH+ /CH- button to step one up or down one channel
b. Display Channel number on upper right corner of screen
c. If button is not released within 2 seconds->jump 5 channels for every 0.5 second
d. When button is released-> return to normal
e. This two buttons only function in TV mode.
5. VOL+/VOL-: to adjust the audio level
a. Press VOL+/VOL- button to change audio volume
b. Volume level is from 0 to 7
c. Level 0 will mute the speaker completely
6. M+/M-: to adjust brightness of screen
a. Press M+/M- to adjust brightness
b. Brightness level is in the range from 1 to 16
7. Reset 2.4G channel to default: to set 2.4G channel to CH1 2.4G RF channel is lost
Press and hold MODE button for 2 seconds or until Video is received on screen
8. IR Remote control learning
Base Station Indications Remote Screen display
a. Press “Learn” key and hold for 2 seconds to
start learning UP key.
Display “Learn Remote Control Keys “ on top of
screen
b Green LED flashing at 4 Hz Display and flash on line above bottom line “Press
and hold Channel Up key of remote control”
c Receive IR code from receiver and stored in
EEPROM
Display on fourth line “Learning Channel Up key”
d If no IR code received within 10 seconds,
return to normal, otherwise
Display on fourth line “No valid key learned”
e Green LED flashing at 1 Hz Display on fourth line “Channel Up Key Learned”
Display and flash on bottom line “Press Learn
button”
f Press “Learn” button to start learning Down
key
Green LED flashing again at 4 Hz
Display and flash on one line above bottom “Press
and hold Channel Down key of remote control”
g Receive IR code from receiver and stored in
EEPROM
Display on fourth line “Learning Channel Down
key”
h Green LED flashing at 1 Hz Display on fifth line “Channel Down Key Learned”
If no IR code received within 10 seconds,
return to normal, otherwise
Display on fifth line “No valid key learned
i Return to normal mode after 10 seconds or
Learn button is pressed
Display and flash on bottom line “Press Learn
button or Wait ”