User's Manual

The Repeater can also be set up on a desk or counter by attaching the

back of the unit to the plastic Pedestal that is included in the package.

This sets the unit at a convenient angle on a flat surface.

5. Once the Repeater is set up, no further attention is required since all

alarm signals will be passed along automatically to the Receiver.

Programming

Before programming, turn on the Receiver by pressing the POWER button.

The red LED power indicator will light.

To Program a Transmitter Location:

NOTE: Before using a particular Transmitter unit for the first time, charge it

for at least 14 hours by placing it into the Charging Cradle. The red LED

on the Charger will light when the Transmitter is properly inserted. This

procedure will help lengthen the life of the battery.

1. Press the PROGRAM button on the Receiver for 2 seconds.

The green LED will light and the LED indicating the first empty station

location will flash.

2. Press the PROGRAM button to select the desired empty location.

The LED of each empty station will light up in turn each time the button

is pushed.

3. Press the CHECK button on the Transmitter until a long beep is heard

from the Receiver and the station LED stops flashing.

4. Press PROGRAM to program the next empty station,

Press CONFIRM on the Receiver to return to normal monitor mode.

Programming can be checked at any time by pressing the CHECK button

on the Transmitter.