User's Manual

To Program a Pendant Location:
1. Press the PROGRAM button on the Receiver for 2 seconds.
The green LED will light and the LED indicating the first empty station
location will flash.
2. Press the PROGRAM button to select the desired empty location.
The LED of each empty station will light up in turn each time the button
is pushed.
3. Press and hold the ALARM button on the Pendant until you hear a long
beep from the Receiver and the station LED stops flashing.
4. Press PROGRAM to program the next empty station,
OR
Press CONFIRM on the Receiver to return to normal monitor mode.
To Program a Wireless Floor Mat Location:
1. Press the PROGRAM button on the Receiver for 2 seconds.
The green LED will light and the LED indicating the first empty station
location will flash.
2. Press the PROGRAM button to select the desired empty location.
The LED of each empty station will light up in turn each time the button
is pushed.
3. Apply pressure to the Floor Mat to activate the mat’s transmitter; the
LED on the transmitter will start to flash. You will hear a long beep from
the Receiver and the station LED will stop flashing.
4. Press PROGRAM to program the next empty station,
OR
Press CONFIRM on the Receiver to return to normal monitor mode.
5. Verify the programming by activating the Wireless Floor Mat to confirm
that the alarm signal is received correctly.
9