User's Manual

Table of Contents
Introduction ························· 1
Location of Controls
Receiver and Transmitter ·············· 2
Pendant and Repeater················ 3
Unpacking·························· 4
Setting Up ························ 5 - 8
Receiver ······················· 5
Transmitter and Charger ············· 5 - 6
Pendant ······················· 6
Wireless Floor Mat·················· 7
Repeater ····················· 7 - 8
Programming······················ 8 - 10
Operation ······················· 10 - 14
Monitoring by Transmitter ············· 10
Monitoring by Pendant ··············· 10
Checking for Programmed Locations ······· 11
Erasing a Programmed Location ·········· 11
Erasing a Repeater Programmed into the Receiver · 11
Alarm Signals at the Receiver ········· 11 - 12
Alarm Signals at the Transmitter ·········· 12
Resetting an Active Alarm Signal ········· 12
Turning Off Alert Signals ·············· 12
Out-of Range Monitoring ·············· 13
Battery-Low Indication ··············· 13
Charging a Transmitter ············ 13 - 14
Transmitter Logout and Standby Mode ······ 14
Safety Instructions: Transmitter Battery Pack ······· 15
FCC Warning ······················· 16
Radio Frequency Interference··············· 16
Limited Warranty ····················· 17