Data Sheet

15/19
DocID027851 Rev 1.0
BLUENRG-M0x
8.2
IC certification
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
In addition, accordingly to RSS-102 clause 2.6, the RF exposure compliance distance
of the BLUENRG-M0x is set equal to 15 mm, as shown in the following Tables.
8.2.1
Modular approval
IC: 8976C-BNRGM0AL
In accordance with IC RSS-247, the BLUENRG-M0x is listed as a modular transmitter
device.
This module is evaluated for stand-alone use only. Finished products incorporating
multiple transmitters must comply with colocation and RF exposure requirements in
accordance with IC multi-transmitter product procedures. Collocated transmitters operating
in portable RF Exposure conditions (e.g. <20cm from persons including but
not limited to body worn and hand held devices) may require separate approval.
Labeling instructions
When integrating the BLUENRG-M0x into the final product, the OEM must ensure that
the IC labeling requirements are satisfied. A statement must be included on the exterior
of the final product which indicates that the product includes a certified module. The label
should state the following (or similar wording that conveys the same meaning):
Contains IC: 8976C-BNRGM0AL
OR
This product contains IC: 8976C-BNRGM0AL
The OEM must include the following statements on the exterior of the final product
unless the product is too small (e.g. less than 4 x 4 inches):
This device complies with RSS-247 of the IC Rules. Operation is subject to the
following two conditions:
 this device may not cause harmful interference,
and
 this device must accept any interference received, including any interference that
may cause undesired operation.
8.2.2 Product manual instructions
This section applies to OEM final products containing the BLUENRG-M0x module, subject
to IC compliance. The final product manual must contain the following statement (or a
similar statement that conveys the same meaning):