Datasheet

STE100P
14/31
11, 10 --- reserved
9 ENRLB Enable remote loop-back function. 1: enable 0: disable 0 R/W
8 ENDCR Enable DC restoration.
0: disable DC restoration.
1: enable DC restoration.
1R/W
7 ENRZI Enable the conversions between NRZ and NRZI.
0: disable the data conversion between NRZ and NRZI.
1: enable the data conversion of NRZI to NRZ in receiving and
NRZ to NRZI in transmitting.
1R/W
6 EN4B5B Enable 4B/5B encoder and decoder
0: the 4B/5B encoder and decoder are bypassed
1: the 4B/5B encoder and decoder are enabled..
1 R/W
5 ISOTX Transmit Isolation. When 1, isolate from MII and tx+/-. The bit
will be set to one if the PHY address is set to 00000 at power-
up/reset This bit must be 0 for normal operation
0R/W
4~2 CMODE Reporting of current operation mode of transceiver.
000: in auto-negotiation
001: 10Base-T half duplex
010: 100Base-TX half duplex
011: reserved
100: reserved
101: 10Base-T full duplex
110: 100Base-TX full duplex
111: isolation, auto-negotiation disable
000 RO
1 DISMLT Disable MLT3.
0: the MLT3 encoder and decoder are enabled.
1: the MLT3 encoder and decoder are bypassed.
0R/W
0 DISCRM Disable Scramble.
0: the scrambler and de-scrambler is enabled.
1: the scrambler and de-scrambler are disabled.
0R/W
PR20- XMC, XCVR Mode control
15~12 --- Reserved 0 RO
11 LD Long Distance mode of 10Base-T.
0: normal squelch level.
1: reduces 10Base-T squelch level for extended cable length.
As the length of the cable increases, so does the current.
0R/W
10~8 --- Reserved 0 RO
Table 5. Register Descriptions (continued)
Bit # Name Descriptions Default Val RW Type