Datasheet

This is information on a product in full production. For further information contact your local STMicroelectronics sales
office.
September 2013 Doc ID 023987 Rev 2 1/9
1
EV-VND5T035AK
VND5T035AK evaluation board
Data brief − production data
Features
■ Simple single IC application board dedicated
for VND5T035AK-E
■ Provides thermal heat-sinking for ease of use
in prototyping
■ Provides electrical connectivity for easy
prototyping
Description
EV-VND5T035AK provides you an easy way to
connect ST’s surface mounted VIPower
®
drivers
into your existing prototype circuitry. This
evaluation board comes pre-assembled with
VND5T035AK-E high-side driver.
The VND5T035AK-E is monolithic device made
using STMicroelectronics
®
VIPower technology,
intended for driving resistive or inductive loads
with one side connected to ground. Active V
CC
pin
voltage clamp protects the device against low
energy spikes.
The device integrates an analog current sense
which delivers a current proportional to the load
current.
Fault conditions such as overload,
overtemperature or short to V
CC
are reported via
the current sense pin. Output current limitation
protects the device in overload conditions. The
device latches off in case of overload or thermal
shutdown.
The device is reset by a low level pass on the fault
reset standby pin.
A permanent low level on the inputs and on the
fault reset standby pins disables all outputs and
sets the device in standby mode.
Figure 1.
VND5T035AK evaluation board
Parameter Symbol Value Unit
Max transient supply
voltage
V
CC
58 V
Operating voltage range V
CC
8 to 36 V
Typ On-State resistance R
ON
35 mΩ
Current limitation (typ) I
LIMH
42 A
Off-state supply current I
S
2 µA
(1)
1. Typical value with all loads connected.
Table 1. Device summary
Order code Reference
EV-VND5T035AK VND5T035AK evaluation board
www.st.com