User's Manual
Table Of Contents
2 Board setup
To set up the board:
Step 1. Connect the X-NUCLEO-NFC06A1 expansion board to the STM32 Nucleo board from the top through
the Arduino UNO R3 connectors
Step 2. Power the STM32 Nucleo
board using a Mini-B USB cable
Step 3. Program the firmware on the
STM32 Nucleo board using the provided example
Step 4. Reset the MCU using the reset button available on the STM32 Nucleo board.
The evaluation kit is ready to be used.
UM2615
Board setup
UM2615 - Rev 1
page 5/17
rev 1 draft B