User manual
Table Of Contents
- Figure 1. STM32 Nucleo-64 board (1)
- 1 Ordering information
- 2 Conventions
- 3 Quick start
- 4 Features
- 5 Hardware layout and configuration
- 6 Mechanical drawing
- 7 Electrical schematics
- 8 References
- 9 Revision history
Hardware layout and configuration UM1724
34/61 DocID025833 Rev 9
Warning: PWM is not supported by D9 on STM32F302 since the timer is
not available on PC7.
Table 13. Arduino connectors on NUCLEO-F303RE
CN No. Pin No. Pin name MCU pin Function
Left connectors
CN6
Power
1NC - -
2 IOREF - 3.3V Ref
3 RESET NRST RESET
4 +3V3 - 3.3V input/output
5 +5V - 5V output
6 GND - Ground
7 GND - Ground
8 VIN - Power input
CN8
Analog
1 A0 PA0 ADC1_IN1
2 A1 PA1 ADC1_IN2
3 A2 PA4 ADC2_IN1
4 A3 PB0 ADC3_IN12
5 A4 PC1 or PB9
(1)
ADC12_IN7 (PC1) or I2C1_SDA (PB9)
6 A5 PC0 or PB8
(1)
ADC12_IN6 (PC0) or I2C1_SCL (PB8)
Right connectors
CN5
Digital
10 D15 PB8 I2C1_SCL
9 D14 PB9 I2C1_SDA
8 AREF - AVDD
7 GND - Ground
6 D13 PA5 SPI1_SCK
5 D12 PA6 SPI1_MISO
4 D11 PA7 TIM17_CH1 or SPI1_MOSI
3 D10 PB6 TIM4_CH1 or SPI1_CS
2 D9 PC7 TIM3_CH2
1D8 PA9 -