Datasheet

RUN
Address: 0x72
Type: RW
Software Reset: 0x00
Hardware Reset: 0x00
MSB LSB
b7 b6 b5 b4 b3 b2 b1 b0
XXXXXXXRUN
Setting this register to 1, STA013 leaves the idle
state, starting the decoding process.
The Microcontroller is allowed to set the RUN
flag, once all the control registers have been in-
itialized.
TREBLE_FREQUENCY_LOW
Address: 0x77
Type: RW
Software Reset: 0x00
Hardware Reset: 0x00
MSB LSB
b7 b6 b5 b4 b3 b2 b1 b0
TF7 TF6 TF5 TF4 TF3 TF2 TF1 TF0
TREBLE_FREQUENCY_HIGH
Address: 0x78
Type: RW
Software Reset: 0x00
Hardware Reset: 0x00
MSB LSB
b7 b6 b5 b4 b3 b2 b1 b0
TF15 TF14 TF13 TF12 TF11 TF10 TF9 TF8
The registers TREBLE_FREQUENCY-HIGH and
TREBLE_FREQUENCY-LOW, logically concate-
nated as a 16 bit wide register, are used to select
the frequency, in Hz, where the selected fre-
quency is +12dB respect to the stop band.
By setting these registers, the following rule must
be kept:
Treble_Freq < Fs/2
BASS_FREQUENCY_LOW
Address: 0x79
Software Reset: 0x00
Hardware Reset: 0x00
MSB LSB
b7 b6 b5 b4 b3 b2 b1 b0
BF7 BF6 BF5 BF4 BF3 BF2 BF1 BF0
BASS_FREQUENCY_HIGH
Address: 0x7A
Software Reset: 0x00
Hardware Reset: 0x00
MSB LSB
b7 b6 b5 b4 b3 b2 b1 b0
BF15 BF14 BF13 BF12 BF11 BF10 BF9 BF8
The registers BASS_FREQUENCY_HIGH and
BASS_FREQUENCY_LOW, logically concate-
nated as a 16 bit wide register, are used to select
the frequency, in Hz, where the selected fre-
quency is -12dB respect to the pass-band. By
setting the BASS_FREQUENCY registers, the
following rules must be kept:
Bass_Freq <= Treble_Freq
Bass_Freq > 0
(suggested range: 20 Hz < Bass_Freq < 750 Hz)
Example:
Bass = 200Hz
Treble = 3kHz
TFS
1514131211109876543210
0000101110111000
BFS
1514131211109876543210
0000000011001000
STA013 - STA013B - STA013T
24/38