Datasheet

Electrical characteristics STM8AF52/62xx, STM8AF51/61xx
56/110 Doc ID 14395 Rev 9
10 Electrical characteristics
10.1 Parameter conditions
Unless otherwise specified, all voltages are referred to V
SS
.
10.1.1 Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
A
= -40 °C, T
A
= 25 °C, and
T
A
= T
Amax
(given by the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production.
10.1.2 Typical values
Unless otherwise specified, typical data are based on T
A
= 25 °C, V
DD
= 5.0 V. They are
given only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range
.
10.1.3 Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
10.1.4 Loading capacitor
The loading conditions used for pin parameter measurement are shown in Figure 8.
Figure 8. Pin loading conditions
50 pF
STM8A pin