Owner Manual

1. Dig a hole the same diameter & depth of plastic basin with
the top of the basin sitting an inch above ground level.
2. Place the pump and tubing in bottom
of basin. Position the metal grid or plastic
support lid (as supplied) on top of the basin.
If supplied, place plastic support pieces
(not shown) inside the basin making
sure they’re evenly spaced.
3. Lay the green plastic mesh across top
of metal grid (if provided) to decrease
evaporation.
4. Place stone feature on top of metal
grid/plastic support lid (as provided).
5. Install the plastic tubing through the
bottom up to the top of the drilled
water feature.
6. Add water to the basin until pump
is submerged by at least 2” of water
and then plug in the pump.
7. Adjust pump pressure as needed
until water is bubbling to desired height.
8. Decorate base of water feature with
polished pebbles for a finished look.
Cable passes
through the
Rubber Sealing
Ring
Plastic
Tubing
Fountain Light
Rubber
Sealing
Ring*
Shine a light
on the subject!
Completely transform your water
feature with the addition of an LED
lighting option! LED lighting provides
a spectacular effect with minimal power
usage. Light kits are included with the
purchase of select Stone Age Creations
Fountain Kits or add your own to your
existing water feature for a dramatic effect.
The simple addition of the rubber sealing
ring around the base of the light creates a tight
seal which forces the flow of water up and out the
center of the light, adding more height to the fountain.
Just Add Water!
Follow these helpful tips for a
worry-free fountain installation.
Stone
Pebbles
Green Plastic
Mesh
Metal
Grid
Plastic
Tubing
Plastic
Tubing
Pump
419.929.2240 | [e-mail] | www.StoneAgeCreations.com
Find helpful instructional videos and see
Stone Age Creations water features in action on Youtube!
*Helpful hint!