Warranty

ManualsBrandsStonepoint LED Lighting ManualsLighting & Ceiling Fans200-Lumen 140-Degree White Integrated LED Motion Activated Outdoor Area Light with Solar Panel

rev082216

500 Lumen LED Motion Solar

Security Light

Model: Z500-7B/Z500-7W

Please read all instructions thoroughly and carefully prior to installing this product.

Retain these instructions for future reference.

Keystone Group assumes no liability or responsibility for claims arising from improper installation or improper use.

For questions in regard to the warranty of this product, contact us at 303.652.6164 or email us at info@keystonegroupusa.com

The batteries in this unit can be replaced. Please use Li Ion Battery # 18650 3.7v Rechargeable Battery for replacement.

Installation Instructions

** Allow the solar light to charge for one full day prior to use. **

Description

Quantity

Light Fixture

Stainless Steel Screw

Wall Anchor (optional)

Wall Bracket

Tools Required for Installation:

Phillips screw driver and level

Solar Panel

LED Lens

Summary of content (4 pages)

PAGE 1
500 Lumen LED Motion Solar Security Light Model: Z500-7B/Z500-7W Please read all instructions thoroughly and carefully prior to installing this product. Retain these instructions for future reference. Keystone Group assumes no liability or responsibility for claims arising from improper installation or improper use. For questions in regard to the warranty of this product, contact us at 303.652.6164 or email us at info@keystonegroupusa.com The batteries in this unit can be replaced.
PAGE 2
MOUNTING THE SOLAR LIGHT The solar light has an easy mount system. The light will mount in three easy steps. Step 1: Drill pilot holes for the mounting bracket on desired wall. Use a level to ensure the wall bracket is straight. Step 2: Screw the mounting bracket to the wall using the two screws provided. You can use the optional mounting anchors included to secure the bracket to the wall (see Figure 1).
PAGE 3
BATTERY REPLACEMENT To replace the battery in the solar light remove the light from the mounting bracket. Step 1: Unscrew the four screws on the back of the light (See Figure 5), and remove cover. Figure 5 Unscrew (4) screws Step 2: Remove battery and replace with new battery (See Figure 6). (Note: Please use Li Ion Battery # 18650 3.7v Rechargeable Battery for replacement) Figure 6 Step 3: Replace battery cover and screw back in the four screws (See Figure 7). Re-hang light.
PAGE 4
TROUBLE SHOOTING Problem Light does not come on Possible Cause 1. Too bright (too much ambient light) 2. Battery is dead 3. Solar Panel Blocked 4. On/Off switch is in the ‘Off’ position Possible Correction 1. Cover light and see if the light triggers on 2. Change battery 3. Make sure solar panel is not blocked 4. Switch the power button to ‘On’ position Light goes on and off continuously Light is sensing reflection Relocate light to area where it cannot sense reflections.