Warranty

rev082216
2
On/Off Switch
MOUNTING THE SOLAR LIGHT
The solar light has an easy mount system. The light will mount in three easy steps.
Step 1: Drill pilot holes for the mounting bracket on desired wall. Use a level to ensure the wall bracket is straight.
Step 2: Screw the mounting bracket to the wall using the two screws provided. You can use the optional mounting anchors
included to secure the bracket to the wall (see Figure 1). (Mounting anchors are optional and not needed if screwed into wood)
Step 3: Slide the light onto the mounting bracket as shown in Figure 2. The light should slide onto the bracket as shown in
Figure 3.
This solar light has a maximum motion detection range of 20 feet and has a motion detection angle of 140°.
The motion light will remain on for approximately 45 seconds after motion is detected.
The solar light has an on/off switch on the back of the light. To manually turn off the light, use the override switch. (See Figure
4).
Figure 4
Figure 2
Figure 1
Figure 3 (Wall Mount View)