Use and Care Manual

Page 1 of 2
Stonewalled™ Basic Application Instructions
Tools Required:
Spray Bottle (or Hudson type garden sprayer for large areas)
Cleaning Tools (bucket, deck brush, etc)
Micro-fiber flat mop
Read all instructions before beginning application process.
Application Conditions
 Surface material needs to be clean and free of all foreign contaminants.
 Surface temperature needs to be greater than 40°F and rising, and less
than 90°F
*** Do not allow surface to get wet / rained on for at least 24 hours after
application. Check the weather report!***
Application Instructions
Step 1: CLEAN SURFACE. We recommend TractionWash.
Dilute TractionWash™ to water in a bucket per these dilution ratios:
1:32 for light cleaning; 1:20 for moderately dirty or greasy surfaces or 1:10 for very dirty or greasy surfaces)
Broadcast Traction Wash mix on area to be treated and agitate with a brush.
Let stand for 10 minutes to begin to break down foreign contaminants. Rinse and extract.
----------------------------------------------------------------------------------------------------------
OPTIONAL STEP FOR CONCRETE SURFACES (if desired.)
If you desire to whiten and brighten the concrete to be treated; follow step 1A
Step 1A: Mix InvisaTread™ (IVT) 1:3 - 1 part IVT to 3 parts water.
- Broadcast IVT mix onto area to be treated and brush to cover
- Let stand for 5 minutes or until surface turns milky-white
- Rinse with 1:20 dilution of Traction Wash™
- Pressure wash or scrub to rinse off material and extract.
------------------------------------------------------------------------------------------------------------------
Step 2: Allow surface to dry thoroughly.
Step 3: Fill sprayer with Stonewalled™ Sealer- DO NOT DILUTE.
 Spray in even smooth overlapping strokes onto surface.
 Use a roller or microfiber flat mop, to cut in areas and corners if desired
 Spray to saturation until the surface will not accept any more product. Try to avoid puddling.
 Consumption should be 225 - 350 sq. ft per gallon. Actual yield may vary depending on porosity of the
surface, ambient and surface temperatures.
 When spraying on vertical surfaces - ALWAYS spray from the bottom, to the top.
 If a horizontal surface is pitched to drain, spray from the bottom of the slope to the top.
Step 5: Allow surface to dry. Test a spot to see if the surface will accept more product. Apply more, if needed.
DO NOT WALK ON SURFACE FOR AT LEAST 4 HOURS. Do not get wet for 12 hrs. Full cure in 5 - 7 days
When surface is fully cured test for hydro-phobicity. Splash some water onto the surface to check for bead like effect.
In a small test area, beading may occur as soon as surface is dry.
Company Profile:
Surface Solutions, LLC
Industry: Surface Engineering
Consulting
Slip Resistant Treatments
Anti-Graffiti Treatments
Website:
www.totalsurfacesolution.com
Corporate Address:
515 Valley St.
Suite 130
Maplewood, NJ 07040
Contact:
[e-mail]
888-842-3356