User's Manual

STONEX R2 PLUS
44
9.2 Angle Offset Measurement
Sighting the direction of the target point to find it from the included angle. Set offset
points for the target point on the right or left sides of and as close as possible to the target
point and measure the distance to the offset points and the horizontal angle of the target
point.
【Procedure of angle offset measurement】
1. Set the offset points close to the target point
(making sure the distance from the instrument station
to the target point and distance to the offset point are
same, the height of the offset points and the target
point are the same), then use the offset points as the
target.
2. Aim at the offset point and press F1: [MEAS] to
measure the distance at P1 in measure mode.
3. Select [
MENU] at P2 in measure mode, and then
select “
4. Offset”, or press F3: [OFST] at P3
directly.
4. Select “
3. Offset/Angle” after inputting
instrument occupied data, see Ҥ6.1 Input the
occupied point data”.
5. Accurately sight the direction of the target point
and press F4: [
OK], the distance and angle of the
target point are displayed.
Target point
Instrument station
Offset point
(Target)
Offset point
(Target)
Menu P1
1.Coordinate
2.Stake out
3.Area
4.Offset
5.MLM
6.REM
7.Resection
Offset
1.Occ. Orientation
2.Offset/Dist
3.Offset/Angle
4.Offset/2Dist
Offset/Angle
SD 10.186m
VA 90.0000gon
HA 64.5154gon
II
Aim at target?
MEAS MOKS