User's Manual

STONEX R2 PLUS
71
6. According the S-O dHA angle to move the rod until
the telescope sight intersect the arc.
7. Repeat moving and measuring the rod until all the
stake data are accepted. Press F4: [ESC] to escape this
program.
19.2 Three Point Arc Staking Out
1. Press F2: [MENU] on P2 of the basic measurement
mode, select 7.Arc Staking out to enter arc staking
out menu, select 1.Occ.Orientation to set the station.
And then select 3.Three point arc to start three-point
arc staking out measurement.
2. Input the coordinate of arc start point.
Press F1[READ] to read the existed coordinate as
stake out coordinate
Press F4:[OK] to set the data.
3.
Input the coordinate of arc end point.
Press F1[READ] to read the existed coordinate as
stake out coordinate
Press F4:[OK] to set the data.
Arc Stakeout
1.Occ.Orientation
2.2pt+radius arc
3.Three Point arc
Define/Start PT
Pt# J1
Np: 0.000
Ep: 0.000
Zp: 0.000
READ R E C MEAS OK
Define/End PT
Pt# J2
Np: 11.282
Ep: -2.130
Zp: 1.503
READ R E C MEAS OK
Are stake out/Measure
Stn : 1.112m
Offset: 0.013m
In: 0.013m
Fill: 0.306m
MEAS OK
Are stake out/Measure
Stn : 1.109m
Offset: 0.003m
In: 0.003m
Fill: 0.006m
MEAS OK