User's Manual
Table Of Contents
- 1. Precautions for safety
- 2. Nomenclature
- 3. Preparation before measurement
- 4. Basic functions
- 5. Instrument settings
- 6. Measurement
- 7. Data management
- 8. Check and adjustment
- 9. Technical features
- 10. Kit components
- Appendix I: Atmospheric correction formula and chart
- Appendix II: Correction for refraction and earth curvature
- Appendix III: Technical drawing
- Limited warranty standard
- Environmental recycling
Stonex R80 Robotic Total Station - User Manual 11
3.2.2. Replace the battery
3.3. Setting up the instrument
Set up the tripod first: extend the extension legs to suitable lengths and
tighten the screws on the midsections. Make sure the legs are spaced at
equal intervals and the head is approximately level. Set the tripod so that
the head is positioned over the surveying point. Make sure the tripod
shoes are firmly fixed in the ground.
1) Remove the battery
- The battery compartment is below the instrument label;
- Pull out the batter housing;
- Pull the battery from the battery housing;
- Remove the battery by pulling it toward you.
2) Mount the battery
- Place the battery into the battery housing, ensuring that the
contacts are facing outward and upward. Click the battery
into position
- Place the battery housing into the battery compartment.
Push the battery housing in until it fits completely into the
battery compartment;