User's Manual
Table Of Contents
- 1. Precautions for safety
- 2. Nomenclature
- 3. Preparation before measurement
- 4. Basic functions
- 5. Instrument settings
- 6. Measurement
- 7. Data management
- 8. Check and adjustment
- 9. Technical features
- 10. Kit components
- Appendix I: Atmospheric correction formula and chart
- Appendix II: Correction for refraction and earth curvature
- Appendix III: Technical drawing
- Limited warranty standard
- Environmental recycling
Stonex R80 Robotic Total Station - User Manual 24
5. Instrument settings
5.1. Touch screen calibration
When you operate on the screen, if your device isn’t responding to your taps, you may need to recalibrate your
screen. In any picture, press the keys combination [F7]+[F6] (Press F7 firstly, then F6) to enter touch screen
calibration. The calibration process is shown in the figure below.
Carefully press and briefly hold stylus on the center of the
target. Repeat as the target moves around the screen.
After all the targets are clicked, the screen will display as left,
tap the screen to register saved data. The screen goes back to
Stylus Properties menu.