User's Manual
Table Of Contents
- 1. Precautions for safety
- 2. Nomenclature
- 3. Preparation before measurement
- 4. Basic functions
- 5. Instrument settings
- 6. Measurement
- 7. Data management
- 8. Check and adjustment
- 9. Technical features
- 10. Kit components
- Appendix I: Atmospheric correction formula and chart
- Appendix II: Correction for refraction and earth curvature
- Appendix III: Technical drawing
- Limited warranty standard
- Environmental recycling
Stonex R80 Robotic Total Station - User Manual 27
T. unit: set the temperature unit between Centigrade and Fahrenheit degree: °C / °F.
ATP. Unit: Set the pressure unit between HPA / mmHg / inchHg / mbar / PSI.
5.2.3. Instrument parameters review
Click on “Data Monitor” window to review the setting parameters.
5.2.4. Auto aim settings
Click on “Auto aim” window to set the length and width of ATR
searching windows.
• H(D) is the horizontal angle dimension and V(D) is the
vertical angle dimension for the ATR window, its unit is
degree. If they are both 180°, the total station will search
inside a window of 180°x180°
• SP is the interval time between tracking points in the
course of tracking
• Los.LK choose the action after losing lock (NO.A, which
means no actions), (start ATR, which means searching
starts), (To the Prev P, which means it goes back to the
previous position and halts)
• Htreshold is the horizontal threshold and Vthreshold is
the vertical threshold. They determine the limits within
which the target is tracked. The corresponding unit is 0.1”,
so if 500 has been set, the instrument will search the point
up to 50 seconds.