User's Manual
Table Of Contents
- 1. Precautions for safety
- 2. Nomenclature
- 3. Preparation before measurement
- 4. Basic functions
- 5. Instrument settings
- 6. Measurement
- 7. Data management
- 8. Check and adjustment
- 9. Technical features
- 10. Kit components
- Appendix I: Atmospheric correction formula and chart
- Appendix II: Correction for refraction and earth curvature
- Appendix III: Technical drawing
- Limited warranty standard
- Environmental recycling
Stonex R80 Robotic Total Station - User Manual 32
5.4. Setup parameters
In the welcome interface, select “BSC Measure” to enter into
the basic measure interface.
Select the [Param] icon.
Here you can set:
• The coordinate order as NEZ or ENZ;
• The station coordinate saving (Save or S.Zero (not
save)). Choosing “Save” you can input the station
coordinates and calculate coordinate of
surrounding point referring to the station. If they
aren’t inputted, coordinates from the previous
input or zero are used;
• The angle Unit as DMS (degree-minutes-seconds),
GON, MIL (milliradians), rad (radians), degree;
• The Distance Unit as m, UsFeet, IntFeet.