User's Manual
Table Of Contents
- 1. Precautions for safety
- 2. Nomenclature
- 3. Preparation before measurement
- 4. Basic functions
- 5. Instrument settings
- 6. Measurement
- 7. Data management
- 8. Check and adjustment
- 9. Technical features
- 10. Kit components
- Appendix I: Atmospheric correction formula and chart
- Appendix II: Correction for refraction and earth curvature
- Appendix III: Technical drawing
- Limited warranty standard
- Environmental recycling
Stonex R80 Robotic Total Station - User Manual 43
6.3. Coordinate measurement
Select the [M. Coor] icon to operate under distance
measurement mode. The vertical and horizontal angles and
the E-N-Z coordinates are displayed.
Press [Mode] to select the distance measure mode: options
are described in 6.2.1. Distance measurement mode.
6.3.1. Setting coordinate of occupied point
After inputting coordinate of occupied point (instrument location), unknown point coordinate will be measured
and displayed with this program.
Click [OCC PT] key.
Input coordinate of occupied point from N to Z and click
[Enter] to return to the coordinate measurement interface.