User's Manual
Table Of Contents
- 1. Precautions for safety
- 2. Nomenclature
- 3. Preparation before measurement
- 4. Basic functions
- 5. Instrument settings
- 6. Measurement
- 7. Data management
- 8. Check and adjustment
- 9. Technical features
- 10. Kit components
- Appendix I: Atmospheric correction formula and chart
- Appendix II: Correction for refraction and earth curvature
- Appendix III: Technical drawing
- Limited warranty standard
- Environmental recycling
Stonex R80 Robotic Total Station - User Manual 44
6.3.2. Setting backsight point
Click [S.BS] key to set backsight point.
Input coordinate of backsight point and click [Enter] key.
A dialog box is ejected as figure shows.
Collimate backsight point, click [Yes] key. And then the
system will define backsight azimuth angle which displays in
the upper left corner of coordinate measurement screen.