User's Manual
Table Of Contents
- 1. Precautions for safety
- 2. Nomenclature
- 3. Preparation before measurement
- 4. Basic functions
- 5. Instrument settings
- 6. Measurement
- 7. Data management
- 8. Check and adjustment
- 9. Technical features
- 10. Kit components
- Appendix I: Atmospheric correction formula and chart
- Appendix II: Correction for refraction and earth curvature
- Appendix III: Technical drawing
- Limited warranty standard
- Environmental recycling
Stonex R80 Robotic Total Station - User Manual 5
CAUTION:
• If touch the instrument with wet hand, there is danger of electric shock.
• Stand or seat on the carrying case, or turn over the carrying case arbitrarily, the instrument maybe
damaged.
• Be careful of the tripod tiptoe when setup or move it.
• Drop the instrument or the carrying case, or use defective belt, agraffe or hinge, instrument damage
could result.
• Do not touch liquid leaking from the instrument or battery. Harmful chemicals could cause burn or
blisters.
• Please assemble the tribrach carefully, if the tribrach is not stable, series damage could result.
• Drop the instrument or tripod, series damage could result. Before use it, check the central screw is
tight.
1.3. Safety standards for laser
R80 series adopts the safe and visible laser based on “Specification Standard of radiant products” (FDA
CDRH.21CFR Part 1040.10 and 1040.11) and “Safety of laser products – parts 1: Equipment classification,
requirements and user’s guide” (IEC 60825-1:2001).
According to above standards, R80 Series is class ⅢA/3R laser products. When the prism or reflective sheet is
selected in Config mode as target, the output is equivalent to the safer class 1.
Once the instrument is damaged, do not disassemble it. You’d better contact STONEX or local dealer.
Laser emitter