User's Manual

STONEX SLAM XH120 – User Manual
12
this standard, the device is classified as Class 1 Laser Product.
3.9 Battery
HANDLING AND STORAGE
Use the battery properly according to the product specification, do not disassemble or short circuit the
battery.
Keep away from sources of heat or ignition: over high temperature will make the cell inflate melt the
separator, causing short circuit.
The storage area should be cool, dry, well ventilated, out of direct sunlight, away from metal or
sharp edge, such as keys pins or wires. Store the battery in a charged state and charge it every 6 months.
3.10 About User
1. The XH120 Handheld Laser Scanner must be used by trained operators only. When operating the
XH120, please always follow basic safety precautions to prevent injury or damage to equipment.
2. The user is required to be a qualified surveyor or have a good knowledge of surveying, in order
to understand the user manual and safety instructions, before operating, inspecting, or adjusting.
3. Do not operate the equipment if it shows obvious defects or damage. Please follow STONEX®
service procedure to repair the equipment.
4. Please use only the components and accessories provided by the manufacturer.
5. Before operating the XH120 for the first time, please read this manual completely.
6. The equipment contains electrical components and mechanical parts, so proper operation is
required. Do not pull or bend the data transmission line forcibly.
7. Do not push any other objects into the data transmission line interface,
8. Place the device out of the reach of children
9. Do not modify or disassemble the XH120 handheld scanner under any circumstance without the
prior written permission of STONEX®. Otherwise, the warranty would not be applied.
3.11 Exceptions from Responsibility
1. The user of this products is expected to follow all operating instructions and make periodic
checks of the product’s performance.
2. The manufacturer assumes no responsibility for results of a faulty or intentional usage or misuse
including any direct, indirect, consequential damage and loss of profits.
3. The manufacturer assumes no responsibility for consequential damage and loss of profits by
any disaster, such as earthquakes, storms, floods etc.
4. The manufacturer assumes no responsibility for any damage and loss of profits, due to a change
of data, loss of data, an interruption of business etc., caused by using the product or an unusable
product.
5. The manufacturer assumes no responsibility for any damage and loss of profits, caused by usage
except for explained in the user manual.
6. The manufacturer assumes no responsibility for damage caused by wrong transport or action,
due to connecting with other products.