User's Manual

STONEX SLAM XH120 – User Manual

The disposal of electric and electronic device as solid urban waste is strictly prohibited: they must be

collected separately.

Contact Local Authorities to obtain practical information about correct handling of the waste, location,

and times of waste collection centers. When you buy a new device of ours, you can give back to our dealer

a used similar device. The dumping of these devices at unequipped or unauthorized places may have

hazardous effects on health and environment.

The crossed dustbin symbol means that the device must be taken to authorized collection centers and

must be handled separately from solid urban waste.

FOR COUNTRIES OUTSIDE EUROPEAN UNION (EU)

The treatment, recycling, collection, and disposal of electric and electronic devices may vary in accordance

with the laws in force in the Country in question.

SAR Information Statement

Your Handheld Laser Scanner is a radio transmitter and receiver. It is designed and manufactured not to

exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal

Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines

and establish permitted levels of RF energy for the general population. The guidelines are based on

standards that were developed by independent scientific organizations through periodic and thorough

evaluation of scientific studies. The standards include a substantial safety margin designed to assure the

safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones

employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the

FCC is 1.6 W/kg. * Tests for SAR are conducted with the Handheld Laser Scanner transmitting at its

highest certified power level in all tested frequency bands. Although the SAR is determined at the

highest certified power level, the actual SAR level of the Handheld Laser Scanner while operating can be

well below the maximum value. This is because the Handheld Laser Scanneris designed to operate at

multiple power levels so as to use only the power required to reach the network. In general, the closer

you are to a wireless base station antenna, the lower the power output. Before a Handheld Laser

Scanner is available for sale to the public, it must be tested and certified to the FCC that it does not

exceed the limit established by the government adopted requirement for safe exposure. The tests are

performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for

each model. The highest SAR value for this Handheld Laser Scanner when worn on the body, as

described in this user guide, is 0.47 W/Kg (Body-worn measurements differ among phoneHandheld

Laser Scanner models, depending upon available accessories and FCC requirements). While there may

be differences between the SAR levels of various phones and at various positions, they all meet the

government requirement for safe exposure. The FCC has granted an Equipment Authorization for this

model phoneHandheld Laser Scanner with all reported SAR levels evaluated as in compliance with the

FCC RF exposure guidelines. SAR information on this Handheld Laser Scanner is on file with the FCC and

can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on FCC ID:

Y44-XH120 Additional information on Specific Absorption Rates (SAR) can be found on the Cellular

Telecommunications Industry Association (CTIA) web-site at http://www.wow-com.com. * In the United

States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged

over one gram of tissue. The standard incorporates a substantial margin of safety to give additional

protection for the public and to account for any variations in measurements.

The SAR test distance is 0mm.