Operating Instructions

4
5. Product Installation
Fig.1 installation instruction
 1st step
Install the sensors on the suitable place. The distance between sensor S6 and S7、S1 and S12 must be
more than 1.5m, and other adjacent sensors should be installed more than 0.5m. Ideally the sensor
should be installed on the vehicle at roughly 0.6m to 0.8m above the ground.
 2nd step
Make sure it is firm and steady.
 Installation of other parts
1. Find the right place for camera mounting. e.g.: Drill a hole to install the embedded style
camera.
2. Find a proper place in the cab to mount the monitor.
3. Master and extension controller should be placed in a clean and dry place.
5. Connection
1. Please pay attention to the custom wire harness for connection between the ultrasonic sensor
kit and the back-up system. Make sure that reverse trigger wire from monitor is connected to
the reversing light, please read manual for reference and find the following drawing for correct
Backup camera
Sensors
Control box
Monitor
Loudspeaker