User manual

Introduction 7
SATA DE110 User's Guide - Rev. A03 StorCase Technology, Inc.
Figure 5: "Universal" Receiving Frame Motherboard
(Rear View)
"Universal" ReceivingFrameRearPanel
(Figure 5)
 I/O Connector (JP1) - The input/output connector provides a standard interface for all
SATA signals (Figure 5).
 DC Power Connector (P1) - A standard 4-pin DC power connector is used to accept
DC power.
 Option Pins (W1)
Factory-Installed Jumper (ID0 & ID1) - Factory-installed jumper. Refer to Table 1 for
on page 14 further information.
Factory-Installed Jumper (Pins 15 & 17) - Factory-installed jumper. DO NOT remove!
Remote Activity LED (RLED) - These pins provide a remote LED device activity indicator
(Pin 13=Cathode, Pin 14=Anode).
 Factory Reserved Pins - These pins are reserved for factory use only - Do not install
jumper under any circumstances!
 Activity Indicator - Pin 13 is used for host connection (cable not included) to the Activity
Indicator (Figures 3A & 3B). Some SATA drives/host controllers provide support for the
Activity Indicator feature (refer to the SATA drive/host controller manufacturer's docu-
mentation for further information).
DC Power Connector
(P1)
P1
+5
+12
GND
1
2
Factory-Installed
Jumper
Cathode Anode
P13
P14
Remote
Activity LED
I/O Connector
(JP1)
JP1
0839A
= Pin 1
W1
Option Pin Connector
(W1)
13
14
34
Factory Reserved Pins
(J2 - No Jumper Installed)
J2
Activity Indicator
(Pin 13)
Reserved
(Pin 14)
Factory-Installed
Jumper