User Manual
DE100i-SWU2X User's Guide - Rev. B01 StorCase Technology, Inc.
Installation 15
Figure 11: Device Spin Down/Up Timer Switch
Adjusting the Spin Down/Up Timer
NOTE: The timer for device spin down is controlled by a small selector, located in a cutout
on the side of the DE100i-SWU2X receiving frame as shown in Figure 11. The
amount of time required for a drive to spin down is approximately 15 seconds or
more. This number can vary depending on the type of SCSI device and
manufacturer (some drives may require 45 seconds or more). The factory
configuration is set for 20 seconds. A different delay time may be selected with
the provided alignment tool. Refer to the SCSI device manufacturers manual for
more information on required device spin down time.