Owner manual

ManualsBrandsStorCase Technology ManualsComputer AccessoriesDX150-KIT

DX150-KIT Installation 1

DX150-KIT User's Guide - Rev. B00 StorCase Technology Inc.

DX150-KIT Installation Instructions

1. Drive Cover 1ea.

2. Drive Bracket 1ea.

3. Filament Washer 4ea.

4. Low Profile Carrier Handle 1 ea.

5. #6-32 x .230 inch Flat Hd. Screw 4 ea.

6. M3, Phillips Flat Hd. Screw 8 ea.

Please note that the drive and carrier unit shown in the illustration above ARE NOT part of

the DX150-KIT.

Figure 1: DX150-KIT Illustrated Parts Breakdown

The DX150-KIT includes the following items:

This document provides detailed installation information for the StorCase



DX150-KIT. This

kit adapts low-profile, 3.5 inch form factor removable media devices to the open front Data

Express

carrier unit (part number DE150i-CSD).

Refer to the Data Express User's Guide for additional operating and installation information.

Refer to the device manufacturer's documentation for additional information regarding jumper

settings, connector locations, and operating instructions.

Summary of content (4 pages)

PAGE 1
DX150-KIT Installation 1 DX150-KIT Installation Instructions This document provides detailed installation information for the StorCase DX150-KIT. This kit adapts low-profile, 3.5 inch form factor removable media devices to the open front Data Express® carrier unit (part number DE150i-CSD). Refer to the Data Express User's Guide for additional operating and installation information.
PAGE 2
DX150-KIT Installation 1. Unpack the DX150-KIT and compare it with the Illustrated Parts Breakdown shown in Figure 1 for an overview of the entire assembly to verify that the kit is complete. A #2 Phillips screwdriver is required to complete the installation. 2. If installing the DX150-KIT into a carrier unit that already has an installed drive, remove the power, I/O and ID select cables from the drive. Remove the drive from the carrier. 3.
PAGE 3
DX150-KIT Installation 3 5. If the drive requires jumper modifications or cable connections to the bottom of the unit (refer to device manufacturer's manual for this information), make these changes now, before installing the drive into the adapter bracket. 6. Attach the drive to the adapter bracket using four (4) M3 screws, as shown in Figure 3. 7. Attach the ID select cable, the I/O and power cables to the drive.
PAGE 4
DX150-KIT Installation Drive Bracket Carrier (Not Included) Cables are not shown attached to the carrier in this illustration for clarity. M 3x5 MM Phillips Flat HD Screws (4 ea.) 0384 Figure 4: Installing the Bracket Assembly into the Carrier Drive Cover 6-32 x .230" Flat HD Screws (2 ea.) 0385 Figure 5: Attaching the Cover the Carrier StorCase Technology Inc. DX150-KIT User's Guide - Rev.