Use and Care Manual

bydash.com

Seing up your Fro-Yo MakerSeing up your Fro-Yo Maker

ASSEMBLY ASSEMBLY

IMPORTANT: The Inner Bowl must be placed in the freezer for 8 - 10 hours prior to use.

Make sure to clean your Dash Fro-Yo Maker and all its components prior to rst use!

1. Insert the Power Unit into the Splash Guard. Make

sure the two clips at the bottom of the Power Unit

are locked into place.

2. Insert Spindle into the Power Unit until it clicks

into place.

3. Insert the Paddle onto the end of the Spindle.

4. Remove the Inner Bowl from the freezer and place

it into the Outer Bowl. Remember, the Inner Bowl

must be frozen for 8 – 10 hours before use.

5. Set the Outer Bowl on a clean, stable and dry

surface before lowering the Motor Assembly on

top of the Inner Bowl. Turn the Motor Assembly

clockwise to lock into position. Make sure the

Splash Guard is securely attached.

6. Plug in the unit and switch the Fro-Yo Maker on by

using the ON/OFF button located on top of the Power

Unit.

Your Fro-Yo Maker must be turned on BEFORE lling

with yogurt.