USER MANUAL CSD123
Mounting Accessories 1
Quick User Guide 2
ANNOUNCEMENTS Please read the Announcements carefully before using this video camera for proper and safe operation, so as to bring its optimum performance into play and extend its service life. Do not expose the video camera to sunshine directly, nor point its lens to sunlight. sensor of the video camera may be damaged.
agent of video camera for wiping if necessary. Do not use organic solvent to clean the video camera. Do not touch the lens surface with fingers. Please back up the data if the memory card inside this video camera is used for the first time. The externally installed memory cards are manufactured from precise electronic components. Data may be lost or damaged under the following circumstances: 1. Improper use of the memory card. 2. The memory card is bent, dropped or collided. 3.
WATERPROOF CASE USING NOTICE Before sealing the waterproof case, keep the camera housing’s rubber seal clean, a single hair or grain of sand can cause a leak. You can test by closing the case without inserting the camera. Submerse the case completely in water for about a minute. Remove the case from the water, dry off its exterior with a towel, then open the case. If the entire interior is dry, the case is safe for use under water.
INTRODUCTION TO APPEARANCE AND KEYPAD ⑺Mode Switch: ⑻Lens ⑼LCD TFT ⑽Working Indicator Light ⑾Indicator Light for charging ⑿Wrist strap eyelet ⑴Memory card slot ⑵Reset ⑶USB slot ⑷Power button ⑸MIC ⑹Shutter button 6
USAGE 1. Charge the built-in lithium battery Indicator Light for charging is on. USB Cable Connect the video camera with computer for charging in the shutdown state. The indicator light for charging is on at this time and will be off after charging. In general, it can be fully charged after 2-4 hours.
2. USE OF MEMORY CARD 1. Push the memory card into the card slot according to the concave lettering beside the slot of memory card till it is completely inserted. 2. To take out the memory card, gently press the end of the memory card inward and it will pop up. Note: No built-in memory is available in this video camera. Make sure to insert memory card before using.
3. STARTUP/SHUTDOWN 3.1 Startup: Press the POWER button for 3 seconds, the screen is displayed and the camera is on. 3.2. Shutdown: Press the POWER Key, and the camera will be shut down. . Automatic shutdown: when the idle time of the video camera reaches the time for automatic shutdown, it will be shut down automatically to save power. The default time of this camera for automatic shutdown is 5 minutes. 3.3.
4. CONVERSION BETWEEN FUNCTION MODES Three modes are available for this video camera, i.e. picture taking mode, video recording mode and vehicle-mounted mode. Conversion is available via the mode switch after startup. Picture taking mode: pictures can be taken; Video recording mode: video can be recorded; Vehicle-mounted mode: videotape can be recorded.
5. INDICATOR LIGHT Busy light: when the camera is busy (such as, recording a film, taking photos, automatic off-screen), the busy light will be on. Charging light: when the light is on for a long time, it prompts the user that the camera is charging. 6.
5 : digital zoom icon, click it and enlarge it. 6 : digital zoom icon, click and minify it. 7 : visual shutter, touch this visible frame for taking photos or recording. 8 : battery icon, represents the power status of the battery. 9 : represents the status of digital zoom. 10 11 : click this icon to switch to the playback mode. : click this icon to set the date and time, finished setting and press Shutter key to confirm.
7 PICTURE TAKING MODE: 1 0/1234: Counter, indicating current number of photos taken already /number of photos to be taken. 2 : mode I con, indicating that the camera is in photo taking mode. 3 : video size, click this icon to select the photo resolution. 4 : means that the memory is been inserted at present. 5 : digital zoom icon, click it to enlarge. 6 : digital zoom icon, click it to minify. 7 : visual shutter, touch this visible frame for taking photos or recording.
8 VEHICLE-MOUNTED MODE: 1 00:12:18 timer, indicating that the camera can still record for 12 minutes and 18 seconds. 2 : mode icon, representing that the camera is in vehicle-mounted mode. 3 : video size, click this icon to select 720P, VGA. 4 : represents that the memory card has been inserted. 5 : digital zoom icon, click it to enlarge. 6 : digital zoom icon, click it to minify. 7 : visual shutter, touch this visible frame for taking photos or recording.
9 PLAYBACK MODE: 9.1 After starting up and entering the previewing state, click the playback icon ( of the LCD to switch to the playback mode: ) at the lower right corner Click 1 : represents that the current file is an AVI video file. 2 : represents that there is one file in the current folder/one file in total. 3 : current folder name (such as: I:\DCIM\100MEDIA 4 : Means that clicking can select files frontwards. 5 : Means that clicking can select files backwards.
9.2 Movie clips playing: Click to pause playing, click to play forward, and click to play backward. 9.3 File deletion: Click YES to delete the current file immediately, or click NO to cancel the request of deletion.
APPLY ON THE PERSONAL COMPUTER Connect to personal computer The camera is provided with the plug and play function. Connect the device to the computer with USB line under turning-on state, then it will be switched into the movable hard disk mode. Icon of movable disk will appear on the window of “my computer”. Photos/videos you have taken are saved in folder I:\DCIM\100MEDIA (I is the movable disk of this device) in the movable disk. Files recorded in vehicle-mounted mode are saved in I:\DCIM\RECORDER.
SAFETY-ENVIRONMENT Your STOREX product has been laboratory tested; it complies with European guidelines corresponding to the CE labelling in force at the time of its launch. Your STOREX product's components are tracable; this demonstrates the product's compliance to environmental guidelines (RoHS) in force at the time of its launch. Once the product has reached the end of its lifespan, don't throw it in a dustbin.
WARRANTY REGISTRATION In order to facilitate the management of your issue, should you contact our support team, we invite you to register your tablet guarantee on our website at the following address: http://garantie.storex.eu For repairing, contact your dealer to repair your tablet under guarantee, or send your request via email to the following address: support@storex.eu or by phone at: France: 01 55 85 82 00 (local call charge to Paris) Spain: 902 110 572 (soporte.es@storex.
20