User's Manual

When the receiver and the transmitter has been in connection status, Press Comb
key for 4 seconds , the transmitter will go into the search mode, the transmitter Status
LED flashes to 2 Hz, and the original receiver interrupted, the receiver will go to the
connected Line mode, the receiving end of the Status LED flashes to 1 Hz. As in the
original transmitter into the search mode of <10 seconds> between the transmitter is
unable to obtain new lines connecting the receiver, transmitter will go into sleep status.
If the transmitter goes into search mode press the button to connect Comb model line,
then the receiving end with the completion of connecting lines.
Receiver in the search mode of connection methods：
Receiver into the search mode, Connect LED flashes to 2 Hz, at this time, if more
than two-transmitters are entered, the registration or connecting line mode, the
receiver will be complete registration with any Transmitter which it has not
Connected.
Transmitter in the search mode of connection methods：
Transmitter into the search mode, Status LED flashes to 2 Hz, at this time, if more
than two-receiver into the search mode, The transmitter will complete the register of
the connection with any receiver which it has not connected to before.
Re-plug the receiver connection：
When the receiver and the transmitter has been in connecting line status, such as
receiver will be inserted under the Wii Remote stuck again, this time receiver turn
into the search mode, Connect LED flashes to 1Hz, the Transmitter part has also
entered search mode, Status LED 1 Hz will flicker, at this time need press the comb
keys for 4 seconds and will automatically make the Transmitter into the search mode
to connect with the receiver line registration or wait for the transmitter dormancy
mode then click Comb awakened transmitter and receiver can be connected to
re-register line.
Battery low voltage detect：
Because the transmitter uses the battery the reason, has established the low
pressure examination electric circuit in the launcher interior, when two battery
voltages are lower than 1.8V time launcher Status LED dodges quickly under the
active status by the 4HZ speed, instructed the battery voltage is somewhat low, needs
to replace the battery.