Installation Guide

ManualsBrandsStorm System ManualsKitchenCategory 3 1-gal. Cedar Exterior Semi-Solid Dual Dispersion Wood Finish

Product Description:

This product decorates and protects exterior wood from weather and temperature changes. This product can be used

on new wood, previously stained wood and new pressure treaded wood with proper preparation. Apply one coat over

previously stain surfaces but two coats will provide maximum protection on new or unfinished wood.

Precautions:

DO NOT use over previously painted, solid stained or varnished surfaces. Temperatures of both air and surface should

be at least 50°F (10°C) during application and drying time. Do not apply in hot sunlight or if wet weather is expected

within 48 hours. Surfaces are slippery when wet. Use caution when walking on wet surfaces during application.

Architectural Specifications:

•Unfinished Wood Decks, Siding, Rails, Posts, Fences, Patios, Screening and Outdoor Furniture;

1 Coat Storm System Dual Dispersion Semi-Solid Finish #345 Series

•Previously Stained Surfaces (after proper preparation);

1 Coat Storm System Dual Dispersion Semi-Solid Finish #345 Series

•Pressure treated wood;

1 Coat Storm System Dual Dispersion Semi-Solid Finish #345 Series

Note: New pressure treated wood must be thoroughly cleaned with Storm System All Surface Cleaner, rinsed clean

and allowed to dry completely before finishing. Do not use interchangeably on the same substrate with other Storm

System products as you may note differences in appearance. Appearance varies with different species of wood.

Samples should be tested on the actual wood being used to insure an acceptable appearance.

Application:

WARNING! If you scrape, sand or remove old paint from any surface, you may release lead dust. LEAD IS TOXIC.

EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN

CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to

control lead exposure. Carefully clean up with a wet mop or HEPA vacuum. Before you start, find out how to protect

yourself and your family by contacting the U.S. EPA/Lead Information Hotline at 1-800-424-LEAD (5323) or log on to

www.epa.gov/lead.

This product is of proper consistency as packaged is to be applied without thinning under normal environmental

application conditions.

Surface Preparation:

Surfaces must be thoroughly dry to allow penetration. Surfaces must be clean and free from all other coatings that

may prevent penetration. Always test a small area before application to the entire surface. All mildewed areas should

be cleaned with Storm System All Surface Mold & Mildew Stain Remover. New pressure treated wood should be

scrubbed with Storm System All Surface Cleaner to remove all surface deposits. Rinse thoroughly and allow to dry.

Application:

Stir thoroughly. The clear base can be tinted up to 8 oz. per gallon with Universal Colorants. This product can be

applied by synthetic brush, roller or spray. Clean brushes and equipment with soap and water and remove spatters

immediately after completion of job. NOTE: for decks, use Storm System CATEGORY 1 100% Acrylic Top Coat

#11550 for longer life and greater durability.

Recommended Use:

For Pressure Treated and Conventional Woods / Sun Decks / Wood Screening / Patios / Siding / Fencing / Benches /

Open Porches / Outdoor Furniture / Railings and Posts / Wood Pool and Garden Enclosures

Safety Information:

Avoid contact with skin. Use only with adequate ventilation. Keep out of reach of children. Protect from freezing. Do not

take internally. Close container after each use.

First Aid: If swallowed, do not induce vomiting. Call a physician immediately.

Dual Dispersion Semi-Solid

No. 345 Series

4/10/2017

STORM SYSTEM™

California Paints ▪ 150 Dascomb Rd. ▪ Andover, MA ▪ 01810 ▪ www.stormsystem.com ▪ 800-225-1141

5/17/2013

Exterior

Type:

Acrylic/Alkyd Dispersion

Specular Gloss:

Volume Solids:

29.0

@ 60°

Solids by Weight:

39.6

Dry Film Thickness:

1.0

mils

Vehicle:

81.0

Pigment:

19.0

Viscosity @ 77 °F:

Maximum VOC:

100

g/liter

Flash Pt °F:

Non-combustible

Thinner:

Water

Product Specifications:

Exposure:

Exterior

(Weight Per Gallon:

9.80

Available Package Sizes:

Gallon 5 Gallon

To Handle:

To Recoat:

hrs.

To Touch:

Drying Times:

lbs. ± .5 lb)

Surface Spread Rate:

s.f./gal.

(Spray Application is 50% of above)

Tools and Equipment:

Smooth:

200-400

Porous:

150-350

s.f./gal.

Brush -

Natural Bristle

Roller -

Medium Nap

Airless Spray -

.011 to .013

±2

±5

(@ 70-77 °F, 50% R.H.)

Soap & Water

Clean Up:

Available Colors and Bases:

See back page

for complete list

Summary of content (2 pages)

PAGE 1
5/17/2013 STORM SYSTEM™ Exterior 4/10/2017 Dual Dispersion Semi-Solid No. 345 Series Product Description: This product decorates and protects exterior wood from weather and temperature changes. This product can be used on new wood, previously stained wood and new pressure treaded wood with proper preparation. Apply one coat over previously stain surfaces but two coats will provide maximum protection on new or unfinished wood.
PAGE 2
5/17/2013 STORM SYSTEM™ 4/10/2017 Exterior Dual Dispersion Semi-Solid No. 345 Series Product Description: Product Specifications: This product decorates and protects exterior wood from weather and temperature changes. This product can be used on new wood, previously stained wood and new pressure treaded wood with proper preparation. Apply one coat over previously stain surfaces but two coats will provide maximum protection or unfinished wood.