Product Manual

ManualsBrandsStormPro ManualsCombinationMaxx Deluxe Heavy Duty Battery Backup Sump Pump System

StormPro MAXX

Metropolitan Industries, Inc.

www.metropolitanind.com

OPERATION MANUAL

Dated: 1/28/08

Supersedes: None

Document No.: SPMAXX-OM Page 1 of 8

www.sumpro.com

Introduction

This manual has been specially created to give

you a thorough understanding of your inverter and

its optimum use. Do spare some time to read

it carefully. In case you should need help at any

time, please feel free to contact or mail us at:

residentialproducts@metropolitanind.com

Any suggestions, comments are welcome.

Thank you for purchasing your StormPro product.

To help insure years of trouble free operation,

please read the following manual carefully.

Knowing Your Inverter

Reasonable care and safe methods should be

practiced. Check local codes and requirements

before installation. This manual contains important

information for the safe use of this product. Read

this manual completely before using this product

and refer to it often for continued safe product use.

DO NOT THROW AWAY OR LOSE THIS MANUAL.

Keep it in a safe place so that you may refer to it

when needed.

2. Risk of electrical shock connect only to a properly

grounded, three pronged grounding type receptacle.

Under any circumstances do not remove the

grounding prong from the power cord.

3.Do not smoke, use sparkable electrical devices or

open ame when working on this unit!

4. Do not install Unit in locations classied as

hazardous per N.E.C., ANSI/NFPA 70 - 1999.

FAILURE TO HEED ABOVE CAUTIONS COULD

RESULT IN INJURY OR DEATH.

The StormPro Back Up System is only to be used

with the StormPro Pump supplied with the Unit.

Using anything other than the Pump supplied with

the system will cause damage to the Unit and void

the warranty.

WARNING

Tools Needed

In The Box

Always disconnect the Unit from the receptacle

power source and battery before handling or making

any adjustments to the system.

Battery Backup Warning:

1. Risk of electrical shock this Unit has not been

investigated for use in outdoor areas.

A pipe wrench, pliers, adjustable wrench, and

screwdriver will be needed.

Vertical Switch

Quick Connect Lead

Assemabaly With Fuse

BA33M Pump

9” Black Jumper

9” Red Jumper

5 AMP MAX

PART# SP20A201

PART# Z FUSE---80

PART# HP20112

PART# Z JUMPER 10

PART# Z JUMPER 11

PART# MI20145

Summary of content (8 pages)

PAGE 1
StormPro MAXX OPERATION MANUAL Dated: 1/28/08 Supersedes: None Document No.: SPMAXX-OM Page 1 of 8 2. Risk of electrical shock connect only to a properly grounded, three pronged grounding type receptacle. Under any circumstances do not remove the grounding prong from the power cord. 3.Do not smoke, use sparkable electrical devices or open flame when working on this unit! 4. Do not install Unit in locations classified as hazardous per N.E.C., ANSI/NFPA 70 - 1999.
PAGE 2
StormPro MAXX Battery Requirements OPERATION MANUAL Dated: 1/28/08 Supersedes: None Document No.: SPMAXX-OM Page 2 of 8 STORMPRO MAXX Your Unit operates on 12VDC battery power when in the power fail mode, a UL. recognized deep cycle marine battery should be used. FIGURE A LEAVE UNPLUGGED UNTIL FIGURE B We recommend: Metropolitan Industries Power + Battery Model# 27-AGM LW 20104 Factory Tel: 800-323-1665 Installation Instructions 1.
PAGE 3
StormPro MAXX OPERATION MANUAL Dated: 1/28/08 Supersedes: None Document No.: SPMAXX-OM STEP 1 Page 3 of 8 STEP 2 AFTER CONNECTING ALL BATTERIES TERMINALS SECURELY, PLUG UNIT INTO 120 V OUTLET AT THIS POINT YOU ARE READY TO CONNECT THE QUICK CONNECTORST Register your product at www.sumpro.com Metropolitan Industries, Inc. www.metropolitanind.
PAGE 4
StormPro MAXX OPERATION MANUAL Dated: 1/28/08 Supersedes: None Document No.: SPMAXX-OM STEP 1 Page 4 of 8 STEP 2 AFTER CONNECTING ALL BATTERIES TERMINALS SECURELY, PLUG UNIT INTO 120 V OUTLET AT THIS POINT YOU ARE READY TO CONNECT THE QUICK CONNECTORST Register your product at www.sumpro.com Metropolitan Industries, Inc. www.metropolitanind.
PAGE 5
StormPro MAXX OPERATION MANUAL Dated: 1/28/08 Supersedes: None Document No.: SPMAXX-OM the battery is fully charged. • The green light should remain flashing indicating that the system is ready for operation. 2. Continuously lit GREEN light indicates that the battery is charging. • The battery is charging due to normal discharge. • The system has run off of the battery and the power supply is recharging the battery to its optimum level. Page 5 of 8 3.
PAGE 6
StormPro MAXX 3. Test run your system on AC power by activating the switch, then unplug the power supply from the electrical outlet and test the pump on DC power by activating the switch. Be sure to plug the power unit plug back into the wall outlet. 4. After a extended period of power lose, your battery voltage will not be adequate to run your pump. However, battery voltage may recover and allow brief periods of operation.
PAGE 7
StormPro MAXX • If electrolyte contacts the skin, wash it off immediately. • If electrolyte contacts the eyes, flush thoroughly and immediately with water. Seek medical attention. • Spilled electrolyte should be washed down with a suitable acid neutralizing agent. A common practice is to use a solution of approximately one pound (500 grams) bicarbonate of soda to approximately one gallon (4 liters) of water. The bicarbonate of soda solution be added until the evidence of reaction (foaming) has ceased.
PAGE 8
StormPro MAXX OPERATION MANUAL Dated: 1/28/08 Supersedes: None Document No.: SPMAXX-OM Page 8 of 8 WARRANTY 1. Coverage and Term. Metropolitan Industries, Inc.