ogue Eco Design Installation User Instructions

13
6.14 Maximum Wood Running
Wood Maximum Running
(Maximum out)
Off / Smoke Control
Setting
Multi-Fuel Running
Start Up
(Maximum In)
28
The maximum wood running setting allows the appliance to
burn at the maximum output when burning wood. Take care
nottooverretheappliance,seeSection11.
6.15 Refuelling on to a low re bed
 Ifthereisinsufcientburningmaterialintherebedtolight
a new fuel charge, excessive smoke emission can occur.
Refuellingmustbecarriedoutontoasufcientquantityof
glowing embers and ash that the new fuel charge will ignite
inareasonableperiod.Iftherearetoofewembersinthere
bed, add suitable kindling to prevent excessive smoke, see
Section 8.
7. Woodburning Conversion Kit
In order to burn wood continuously in a Multi-Fuel product
StovaxadvisettingaWoodburningConversionkittoyour
appliance.
The kit focuses primary air to the centre of the appliance
whichhelpstoestablishaameandalsoreplicatesthe
recommended conditions for burning wood.
For details on purchasing a Woodburning Conversion kit for
this appliance contact your retailer.
29
 TottheWoodburningConversionkit:
7.1 Remove the Brick Protector and the Log Guard (Pre-
Installation, Sections 2 & 4).
7.2 Manoeuvre the Woodburning plate carefully through the
reboxatanangle.
 Placeatonthegrate,ensuringthe4slotsontheplatealign
with the 4 existing slots in the Multi-Fuel grate, see Diagram
30 & 31.
30
31
7.3 Replace the Brick Protector and Log Guard, see Diagram 32.
32
User Instructions