ogue Eco Design Installation User Instructions

32
Installation Instructions
A Typical Top Flue Pipe Installation
Connection to chimney as
detailed in Building Regulations
135˚Elbowwith
access cover
Flue Pipe x
612 long
600mm minimum
1000mm max
unsupported
All Models
9
4. Rear Flue Installation
 Becausetheapplianceissuppliedfortopueexit,the
blanking plate will need to be moved to the top of the
applianceandtheadditionalrearuecollaranduepipe
ttedtotherear:
4.1 Tools required - cross-headed screw driver, 13mm A/F
spanner/socket wrench.
4.2 Tochangefromtoptorearexitue,reversetheuecollar
and blanking plate using the method detailed:
 —Removethebafe.
— Remove the two side bricks and then the two upper
bricks.
10
Blanking
Plate
Flue Collar Inner
Top
Firebrick
Bafe
Flue Collar
Vogue Midi Shown
4.3 First remove the deector plate.
— Use 13mm A/F spanner/socket to remove 1 x M8 from
each of the 2 front studs.
 Thedeectorplateshoulddropdownanditcanbemoved
clear of the rear support shelves and out through the front of
therebox.
11
Appliance Top
Flue Collar
DeectorPlate
M8 Nut
DeectorPlate
Blanking Plate
Flue Collar
4.4 Remove the blanking plate using a 13mm A/F Spanner/
Socket wrench to take off the 4 M8 half nuts from the outside
of the back plate of the appliance.
Remove the blanking plate from the rear of the back plate
leaving the 4 studs in place.
12
Deflector
Plate
Stove Top
Blanking Plate
M8 Nut
Flue
Collar
Stove
Back
M8 Nut
4.5 To remove the ue collar remove the 4 M8 nuts front and
back. The collar will then drop down inside the appliance.
4.6 Fittingtheuecollarandblankingplateforrearue:
 —Fittheblankingplatetothetopueoutletusing
4 M8 nuts.
 —Sealtothereboxusingrecement.
 —Slidethedeectorplateontothe2frontstudsonthe
underside of the appliance top and rest back edge on the
2 support shelves on the inside rear.