ogue Eco Design Installation User Instructions

34
Installation Instructions
5.3 Remove the levelling feet from the front of the appliance
base.
17
5.4 The Standard Plinth front is removable. It is advisable to
remove this before fitting the appliance to the plinth.
Lift the plinth front so that the cast panel clears the 2 slots on
the plinth to remove, see Diagram 18.
To remove the Midline Plinth undo the 4 screws on the back
of the cast front panel.
Door Cast Panel
Plinth Slots
18
Standard Plinth shown
5.5 Lift the appliance onto the plinth:
— Line up the 2 side plinth braces with the 4 plinth
spacers (two each side) on the inside of the appliance.
19
Standard Plinth shown
Ensure the sides and front of the appliance are sitting level
andushwiththeplinth.
5.6 Fix the appliance to the plinth using the 2 M8 screws and 2
M8 washers provided.
20
Standard Plinth shown
M8 screw &
Washer
M8 screw &
Washer
5.7 Standard Plinth
Locate the cast panel in the 2 fixing slots to fit the plinth
front, see Diagram 21.
Plinth Slots
21
Standard Plinth shown
5.8 Midline Plinth
Line up holes.
Replace and tighten the 4 screws on the rear of the cast
front panel.