ogue Eco Design Installation User Instructions

8
5. Lighting the Appliance
5.1 For best results set air controls as shown, see Diagram 12.
Off
(Maximum Out)
Nominal Running
Smoke Control Setting
(if enabled)
Maximum Running
Start Up
(Maximum In)
Wood Models
12
Multi-fuel Models
Wood Maximum Running
(Maximum out)
Off / Smoke Control
Setting (If enabled)
Multi-Fuel Running
Start Up
(Maximum In)
5.2 If the appliance has been previously used rake any ash
remaining from the previous burn level in the firebox.
Approximately 25mm of ash can be left for a good base for
starting the new fire. Take care as hot embers can remain in
the fuel bed for a long time after the stove was last used.
Multi-Fuel Burning Stove
4.5 If the Smoke Control setting is enabled, the air control slider
must be set to the following:
10
Wood Maximum Running
(Maximum out)
Off / Smoke Control Setting
Multi-Fuel Running
Start Up
(Maximum In)
4.6 If the Smoke Control kit is enabled the air control slider will be
pulled out 47mm, see Diagram 11.
11
Side View
47
4.7 To meet the requirements of a Smoke Control Area the
appliance MUST be operated correctly in order to minimise
the amount of smoke produced.
If this appliance is installed outside of a Smoke
Control Area then the Smoke Control setting can be
disabled to give more control over the lower burn
rates.
Any modifications should only be done by a
suitably qualified installer and must be done at the
time of installation.
These instructions must be left with the User.
User Instructions