ogue Eco Design Installation User Instructions

User Instructions

5.3 To create an open stack for top down lighting:

1. Place two medium sized logs parallel on the base of

the firebox.

2. Place two smaller logs on top running parallel across

the bottom logs.

3. Continue to build the stack using smaller logs and

place firelighters in the centre.

4. Finish the stack by adding two further logs and placing

firelighters on top. Add extra smaller kindling if desired.

5.4 Light the upper firelighters. This will create a flame that will

ignite the logs/ kindling whilst warming the flue to accelerate

the flue draw, see Diagram 14.

5.5 Adjust the operating air controls to the maximum, or

start-up, setting and close the door.

5.6 Leave the fire to establish and develop a glowing firebed

(this may take 30 to 45min or more in some cases).

5.7 Once the fire is established refuel as described in Section 8.

Do not load fuel above the log guard and the secondary

combustion chamber at the back of the rebox, See

Diagram 15.

Wood

Multi-Fuel

Log bar

Secondary Combustion Chamber

5.8 Close the door and follow the instructions for Running

the Appliance.

Do not run with the door slightly open except for initial

lighting as this could cause over-ring and damage the

appliance.