PARTS AND OPERATION MANUAL STOW VIBRATOR HEADS © COPYRIGHT 2002, MULTIQUIP INC. MODELS 900, 1000, 1300, 1400, 1700, 2100 & 2600 MODEL # SERIAL # Revision #1 (04/22/02) STOW CONSTRUCTION EQUIPMENT PARTS DEPARTMENT: A DIVISION OF MULTIQUIP INC. POST OFFICE BOX 6254 CARSON, CA 90749 310-537-3700 • 888-252-STOW [888-252-7869] FAX: 310-537-1986 • FAX: 800-556-1986 E-MAIL: stow@multiquip.com • WWW: stowmfg.
HERE'S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING PARTS DEPARTMENT 800-427-1244 or 310-537-3700 FAX: 800-672-7877 or 310-637-3284 SERVICE DEPARTMENT/TECHNICAL ASSISTANCE 800-478-1244 or 310-537-3700 FAX: 310- 537-4259 WARRANTY DEPARTMENT 888-661-4279, or 310-661-4279 FAX: 310- 537-1173 MAIN 800-421-1244 or 310-537-3700 FAX: 310-537-3927 VIBRATOR HEADS — PARTS & OPERATION MANUAL — REV.
VIBRATOR HEADS— TABLE OF CONTENTS Here's How To Get Help ............................................ 3 Table Of Contents ..................................................... 4 Parts Ordering Procedures ....................................... 5 Safety Message Alert Symbols ................................. 6 Rules For Safe Operation ......................................... 7 MQ STOW - VIBRATOR HEADS Preparation & Operation ........................................... 8 Maintenance ........................
VIBRATOR HEADS— PARTS ORDERING PROCEDURES n n n n n n n Dealer account number Dealer name and address Shipping address (if different than billing address) Return fax number Applicable model number Quantity, part number and description of each part Specify preferred method of shipment: • • • • UPS Ground UPS Second Day or Third Day* UPS Next Day* Federal Express Priority One (please provide us with your Federal Express account number)* • • Airborne Express* Truck or parcel post *Normally shipped the sa
VIBRATOR HEADS— SAFETY MESSAGE ALERT SYMBOLS FOR YOUR SAFETY AND THE SAFETY OF OTHERS! Safety precautions should be followed at all times when operating this equipment. Failure to read and understand the Safety Messages and Operating Instructions could result in injury to yourself and others. HAZARD SYMBOLS Engine exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can cause death if inhaled.
VIBRATOR HEADS— RULES FOR SAFE OPERATION WARNING: Failure to follow instructions in this manual may lead to serious injury or even death! This equipment is to be operated by trained and qualified personnel only! This equipment is for industrial use only. ■ ALWAYS check the equipment for loosened threads or bolts before starting. ■ NEVER use accessories or attachments, which are not recommended by Stow for this equipment. Damage to the equipment and/or injury to user may result.
VIBRATOR HEADS—PREPARATION & OPERATION This safety alert symbol is used to attract your attention. Personal safety is involved. When you see this symbol, become alert; heed its message. WARNING! MAKE CERTAIN the motor is disconnected from the power source and the switch is in the "OFF" position. WARNING! 4. 1.
VIBRATOR HEADS— MAINTENANCE MAINTENANCE Figure 3. Head Parts Reference Number Description 1 ....................... Housing CAUTION! DO NOT allow the vibrator head to wear below the following dimensions: See General Specifications - page11. 2 ....................... Nut or Screw 3 ....................... Bearing 4 ....................... Spindle 5 ....................... Seal The vibrator heads should be inspected and lubricated after every 100 hours of use. Refer to (Figure 3). 10 ...................
VIBRATOR HEADS — MAINTENANCE 4. Remove the cap screw or hex nut that holds the lower bearings in place. (Ref. 2) 5. Remove the spindle with the upper bearings still attached. The lower bearings (tip-end) can now be removed from the housing.(Ref. 4) 6. Remove and discard the oil seals. Note the way the seals face so that the new seals will be installed correctly. (Ref. 5) 7. Thoroughly clean all parts with a degreasing solvent and blow dry with air.
VIBRATOR HEADS — SPECIFICATIONS SPECIFICATIONS TABLE 3. GENERAL SPECIFICATIONS Model 900 1000 1300 1400 1700 2100 2600 Weight 1 lb. 11 oz. 2 lb. 6 oz. 4 lbs. 11 oz. 4 lbs. 10 oz. 6 lbs. 4 oz. 8 lbs. 11 oz. 12 lbs. 10 oz. Length 15" 14" 15" 15" 14" 13" 13" Manufacturing Diameter 7/8 1 - 1 /1 6 1 - 3/8 1 - 3/8 1 - 11/16 2 - 1/8 2 - 5/8 Minimum Wear Diameter 13/16 1 1 - 1/4 1 - 1/4 1 - 9 /1 6 1 - 7/8 2 - 1/4 Head Lube Capacity 1/2 oz. 1/2 oz. 1/2 oz. 1/2 oz.
VIBRATOR HEADS — SEAL INSTALLATION SEAL INSTALLATION SHAFT END HEAD END 2. Seal lip to face vibrator head end. 1. Seal lip to face vibrator shaft end. Figure 4. Seal Installation ■ Seal outer case to face outer case of first seal pressed into casing adapter. ■ Depending on vibrator head model, casing adapter may not appear exactly as shown. CAUTION! Improper seal installation may cause premature head failure. PAGE 12 — VIBRATOR HEADS— PARTS & OPERATION MANUAL — REV.
NOTE PAGE VIBRATOR HEADS — PARTS & OPERATION MANUAL — REV.
SV-SERIES — VIBRATOR HEAD ASSY. VIBRATOR HEAD ASSY. PAGE 14 — VIBRATOR HEADS— PARTS & OPERATION MANUAL — REV.
SV-SERIES — VIBRATOR HEAD ASSY. VIBRATOR HEAD ASSY. ITEM NO. PART NO.
SV-SERIES — VIBRATOR HEAD ASSY. VIBRATOR HEAD ASSY. PAGE 16 — VIBRATOR HEADS— PARTS & OPERATION MANUAL — REV.
SV-SERIES — VIBRATOR HEAD ASSY. VIBRATOR HEAD ASSY. ITEM NO. PART NO.
TERMS AND CONDITIONS OF SALE Effective: July 1, 2000 PAYMENT TERMS 4. Terms of payment for parts are net 10 days. FREIGHT POLICY All parts orders will be shipped collect or prepaid with the charges added to the invoice. All shipments are F.O.B. point of origin. Multiquip’s responsibility ceases when a signed manifest has been obtained from the carrier, and any claim for shortage or damage must be settled between the consignee and the carrier. Freight is at the sender’s expense.
NOTE PAGE VIBRATOR HEADS — PARTS & OPERATION MANUAL — REV.
PARTS AND OPERATION MANUAL HERE'S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING PARTS DEPARTMENT 800-427-1244 or 310-537-3700 FAX: 800-672-7877 or 310-637-3284 SERVICE DEPARTMENT/TECHNICAL ASSISTANCE 800-478-1244 or 310-537-3700 FAX: 310- 537-4259 WARRANTY DEPARTMENT 888-661-4279, or 310-661-4279 FAX: 310- 537-1173 MAIN 800-421-1244 or 310-537-3700 FAX: 310-537-3927 STOW CONSTRUCTION EQUIPMENT PARTS DEPARTMENT: A DIVISION OF MULTIQUIP INC.