User Manual

3
Assembly
1. Screw the optical bracket on to the base (see the left picture above, P2 ).
2. Once you have done so, if the bracket is not aligned over the base, unscrew the locking ring, adjust
the bracket‟s direction, and then turn the locking ring clockwise until it is tight.
(After doing this, it will still be possible to hold the base and
turn the bracket if sufficient force is applied, but it will not spin freely. )
3. Loosen the small thumbscrews on the optical bracket.
4. Slide the optical stack in to the ring of the optical bracket.
5. Tighten the thumbscrews to hold the optical stack in place.
If done correctly, you should be able to not just turn the focus controller of the optical stack freely, but
also freely adjust the monitor, the angle between the base and the optical bracket, while the rest of
microscope remains in place. If you have any question or problem for assembly, please contact us as
soon as possible, so you won‟t damage the device during assembly.
Buttons
(P4, buttons)
① Power on/off
② Mode/menu
③ Up
④ Down
⑤ OK/Start video record
⑥ Picture capture
⑦ Infrared sensor (when you are using the
remote, please point the remote to this so
the device would response)
⑧ Light controller
⑨ Focus controller
⑩ Memory card slot
11 USB port