User Manual

Confidential
Patent #’s 7,420,471
5,939,986 and 6,810,353
Patent Pending
Page 5 of 6
Strata Proximity Systems Surface Proximity Module Users Manual v1.0
Confidential and Proprietary
October 6, 2011
1.4 FCC Information
The FCC ID for the Underground Proximity Generator is ZQ3-SPS-SPROX. When configured by
Strata for underground use, the device complies with Part 15 of the FCC Rules. Operation is
subject to the following conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including interference that may
cause undesired operation.
Any intentional or unintentional changes or modifications to the configuration of the Surface
Proximity Module not expressly approved by Strata Proximity Systems LLC could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
2 Operation
2.1 Installation Information
The Surface Proximity Module is mounted on a vehicle or piece of machinery. Metal near the
Surface Proximity Module may impact performance. After installing the Surface Proximity
Module on the machine, performance of the unit should be verified by calibration and test.
2.1.1 Interoperability Warning
The Surface Proximity Module may experience erratic responses when in very close proximity
to some electronic devices. Electrical devices may transmit an electrical field and noise from
these fields may cause interference with the Surface Proximity Module. A safe guideline is to
keep the Surface Proximity Generator at least 75 mm away from any electrical devices included
but not limited to methane monitor, radio, mobile phone, GPS,PDA, battery charger and laptop
computers.