User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
DOC-24000 Rev. A 7–43
Alaris30 User Guide
Weight Calibration Afterthesuccessfulinstallationofprintheads,thewizardbeginsthe
weighttest,inwhicheachheadprintsasample.Thistesttakes15–25
minutes.
Figure 7-61: Weight test progress screen
14. Carefullyremovethesamplesforeachhead,keepingtrackofthehead
thatprintedthem.
Figure 7-62: Samples printed on the Alaris printer build tray
15. Usingthescale,weigheachsampleandentertheweight(ingrams)for
thecorrespondingheadinthewizardscreen.
16. Closetheprintercover,thenclick
Next.
Figure 7-63: Weight Test data entry screen
Support Print Head Model Print Head
DRAFT 4 - July 11, 2010