User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
Using Objet Studio
5–6
DOC-24000 Rev. A
Arranging the Objet Studio Screen
Thedefaultscreenlayoutdisplaystheperspectiveviewofthebuildtrayand
thetrayhierarchypane,whichliststheelementsplacedonthetray(see
figure 5‐5onpage 5‐4).Youcanviewmodelsfromdifferentanglesby
changingthescreenlayout.
To change the Objet Studio screen layout:
¾
FromtheViewmenu,selectLayout,thenthedesirednumberofbuild‐
trayviews.
2 Viewsisthedefaultscreenlayout,alreadydisplayed(seefigure 5‐5
onpage 5‐4).
Bydefault,theobjectpropertiesdialogboxisalsodisplayed.
3 Viewsaddstopandfrontviewstothedefaultscreenlayout(see
figure 5‐8,below).
4 Viewsdisplaystop,frontandrightviews(seefigure 5‐9).
1 Viewexpandstheperspectiveviewtofillthescreen(seefigure 5‐10).
¾ Youcanalsochangethescreenlayoutwithtoolbaricons.
Figure 5-7: Screen layout icons
Figure 5-8: 3-view screen layout
DRAFT 4 - July 11, 2010